After a recent software update I was unable to switch back to AP mode. The Handibot is also no longer connected to the wifi used for the update, so I tried to reset via the small black button near the Edison board. This has been unsuccessful so far. ( I unplugged the main power cord, disconnected the USB on top of the Edison board to get access to the reset button, which I pressed and held for a good 30 seconds. ) Any suggestions? Thanks Russhttps://handibot.com/forum/read.php?2,1747,1747#msg-1747Wed, 16 Sep 2026 02:58:43 -0400 Phorum 5.2.22 https://handibot.com/forum/read.php?2,1747,1751#msg-1751 https://handibot.com/forum/read.php?2,1747,1751#msg-1751
It acts like it is still connected to a wireless lan, but there is only one network it can join and that router doesn't show it as connected.

if you could send a replacement card I would appreciate it.

Russ]]> Russ Miller Handibot ForumThu, 08 Sep 2016 23:19:05 -0400 https://handibot.com/forum/read.php?2,1747,1750#msg-1750 https://handibot.com/forum/read.php?2,1747,1750#msg-1750
I'm sorry to hear that those steps didn't work. I'm still working with the Fabmo guys on a fix for you. The fastest way that I can see to fix this is to have a new card flashed for you and overnighted to you. I know that you also need to use an indexer so we will make sure that the unit values are set up correctly for that.

One last thing to check...are you able to access the updated by typing :81 after the IP you use to connect to the tool? I know you said it wasn't broadcasting in AP but I thought it might be worth a try. If you can get to the updater, you can run a factory reset which should restore the dashboard]]> Brian Owen, ShopBot Handibot ForumThu, 08 Sep 2016 17:43:27 -0400 https://handibot.com/forum/read.php?2,1747,1749#msg-1749 https://handibot.com/forum/read.php?2,1747,1749#msg-1749 Russ Miller Handibot ForumThu, 08 Sep 2016 14:44:32 -0400 https://handibot.com/forum/read.php?2,1747,1748#msg-1748 https://handibot.com/forum/read.php?2,1747,1748#msg-1748
I replied to your email as well but I'll post a reply here as well for others' information.

There is a Tool Finder program that we've written for locating your tool on the network (it's possible that it is on a local wifi network). You can download it here: [handibot.com]

You can also try the alternative method for sending the tool to AP mode--pressing and holding the green button on the top of the tool for 10 seconds.]]> Brian Owen, ShopBot Handibot ForumThu, 08 Sep 2016 12:45:11 -0400 https://handibot.com/forum/read.php?2,1747,1747#msg-1747 https://handibot.com/forum/read.php?2,1747,1747#msg-1747
This has been unsuccessful so far. ( I unplugged the main power cord, disconnected the USB on top of the Edison board to get access to the reset button, which I pressed and held for a good 30 seconds. )

Any suggestions?

Thanks

Russ]]> Russ Miller Handibot ForumThu, 08 Sep 2016 12:20:31 -0400