Hello, Looking to make a replacement piece for one of our machines. I made the drawings and started to proceed cutting the piece out. The material is a White Delrin Acetal resin sheet 1 inch thick. I choose a 5.5 x 7 tile export with 6 different tiles. The cuts look fine and start off well but once its starts getting into the meat for like 10 seconds later will create a common error 57. I replaced the cord to the Machine and even moved working from the garage to the house thinking maybe there could be power issues. Sometimes it runs longer than other runs but I need to completely reset The Z-axiz everytime and start from the beginning. I spend more time resetting the machine tand cutting air than material. I have a flat up cut 1/4 inch bit for soft and hard plastics. Its set to 9 levels of cuts with a speed of 2 inches per second. I'm thinking that maybe slowing it down to 1 inch per second might work to help prevent the error 57. I haven't tried it yet but was going to tomorrow. Any insight into the error would be appreciated. Kind Regards Rengizedhttps://handibot.com/forum/read.php?2,2379,2379#msg-2379Sun, 09 Aug 2026 10:08:53 -0400 Phorum 5.2.22 https://handibot.com/forum/read.php?2,2379,2381#msg-2381 https://handibot.com/forum/read.php?2,2379,2381#msg-2381
We've also found that plugging a USB hub into your computer and then connecting that to the tool's usb cable will isolate the tool from any noise being experienced by the computer.]]> Brian Owen, ShopBot Handibot ForumMon, 10 Apr 2017 11:08:14 -0400 https://handibot.com/forum/read.php?2,2379,2379#msg-2379 https://handibot.com/forum/read.php?2,2379,2379#msg-2379
Looking to make a replacement piece for one of our machines. I made the drawings and started to proceed cutting the piece out. The material is a White Delrin Acetal resin sheet 1 inch thick. I choose a 5.5 x 7 tile export with 6 different tiles.

The cuts look fine and start off well but once its starts getting into the meat for like 10 seconds later will create a common error 57. I replaced the cord to the Machine and even moved working from the garage to the house thinking maybe there could be power issues. Sometimes it runs longer than other runs but I need to completely reset The Z-axiz everytime and start from the beginning. I spend more time resetting the machine tand cutting air than material.

I have a flat up cut 1/4 inch bit for soft and hard plastics. Its set to 9 levels of cuts with a speed of 2 inches per second.
I'm thinking that maybe slowing it down to 1 inch per second might work to help prevent the error 57. I haven't tried it yet but was going to tomorrow. Any insight into the error would be appreciated.

Kind Regards
Rengized]]> rengized Handibot ForumSat, 08 Apr 2017 21:18:51 -0400