What is a easy way to tile on the y axis on the large sheet tool, can you add tick marks on the machine?https://handibot.com/forum/read.php?2,2819,2819#msg-2819Tue, 21 Jul 2026 12:24:03 -0400 Phorum 5.2.22 https://handibot.com/forum/read.php?2,2819,3025#msg-3025 https://handibot.com/forum/read.php?2,2819,3025#msg-3025 rasbldrs Handibot ForumSun, 18 Mar 2018 07:01:57 -0400 https://handibot.com/forum/read.php?2,2819,3023#msg-3023 https://handibot.com/forum/read.php?2,2819,3023#msg-3023 rasbldrs Handibot ForumFri, 16 Mar 2018 19:04:29 -0400 https://handibot.com/forum/read.php?2,2819,3021#msg-3021 https://handibot.com/forum/read.php?2,2819,3021#msg-3021 Brian Owen, ShopBot Handibot ForumFri, 16 Mar 2018 12:15:43 -0400 https://handibot.com/forum/read.php?2,2819,3020#msg-3020 https://handibot.com/forum/read.php?2,2819,3020#msg-3020 rasbldrs Handibot ForumFri, 16 Mar 2018 05:32:57 -0400 https://handibot.com/forum/read.php?2,2819,2822#msg-2822 https://handibot.com/forum/read.php?2,2819,2822#msg-2822
When I do long things (signs in my case as well)--I just use any edge that is perpendicular to the lumber when I have the tool set in place. Probably the easiest to see would be the inside edge of the yellow plate at the front of the tool.

What I typically do is pre-mark the board with a tape measure and just slide the tool along until my chose edge meets up with my mark.]]> Brian Owen, ShopBot Handibot ForumWed, 22 Nov 2017 06:53:26 -0500 https://handibot.com/forum/read.php?2,2819,2821#msg-2821 https://handibot.com/forum/read.php?2,2819,2821#msg-2821 rasbldrs Handibot ForumTue, 21 Nov 2017 18:44:36 -0500 https://handibot.com/forum/read.php?2,2819,2820#msg-2820 https://handibot.com/forum/read.php?2,2819,2820#msg-2820 Brian Owen, ShopBot Handibot ForumTue, 21 Nov 2017 12:00:43 -0500 https://handibot.com/forum/read.php?2,2819,2819#msg-2819 https://handibot.com/forum/read.php?2,2819,2819#msg-2819 rasbldrs Handibot ForumTue, 21 Nov 2017 05:33:13 -0500