When I push the red button on the handibot to stop the machine to adjust something I can not start it again. On the computer it says Quit or Resume you can not do either the computer is froze, only way to resume is to turn off the handibot and start over. Also when cutting yesterday I noticed a delay, I was using the arrows to move the router and would be a couple second delay more it would move, nothing different on Wi-Fi set up. One last thing when tiling in the Y axis I put marks at 24" and does not line up correctly, I take my laser and mark my x=0, y=0 move the router to the end and mark where the laser line is and only 23 5/8" is that what I should be putting in for the y tile ? Thanks in advance to all these newbie questions Bobhttps://handibot.com/forum/read.php?2,3001,3001#msg-3001Sat, 18 Apr 2026 09:59:14 -0400 Phorum 5.2.22 https://handibot.com/forum/read.php?2,3001,3184#msg-3184 https://handibot.com/forum/read.php?2,3001,3184#msg-3184
Thank you

Rob]]> n1rlu Handibot ForumFri, 24 Aug 2018 23:17:45 -0400 https://handibot.com/forum/read.php?2,3001,3002#msg-3002 https://handibot.com/forum/read.php?2,3001,3002#msg-3002For the older cards (red sparkfun board and little USB cables) I think that a small router or hub is required...that's something I need to work out for my instructions.

I mention this because, after trying out the ethernet connection I found the responses of the tool to be sooooo drastically improved. Latency is cut by at least a factor of 10 (ping time) and the manual controls are super responsive. It is a much better experience.

So I think that some of the freezing issues are software bug related--but many of them may be latency related.

I'll post a new topic when I have the details worked out.]]> Brian Owen, ShopBot Handibot ForumMon, 05 Mar 2018 11:39:42 -0500 https://handibot.com/forum/read.php?2,3001,3001#msg-3001 https://handibot.com/forum/read.php?2,3001,3001#msg-3001
Also when cutting yesterday I noticed a delay, I was using the arrows to move the router and would be a couple second delay more it would move, nothing different on Wi-Fi set up.

One last thing when tiling in the Y axis I put marks at 24" and does not line up correctly, I take my laser and mark my x=0, y=0 move the router to the end and mark where the laser line is and only 23 5/8" is that what I should be putting in for the y tile ?

Thanks in advance to all these newbie questions Bob]]> rasbldrs Handibot ForumMon, 05 Mar 2018 05:35:15 -0500