I was cutting a simple test job today on some MDF and my bot quit in the middle of the job. I turned the power off, waited for a bit but when I turn it back on after a second or so all that happens is one short simultaneous flash of a number of lights on the control card as well as the interface board. I blew any dust out of the enclosure and reseated the control card and ribbon connections, no change. I don't know what else to try, if anyone out there has any suggestions they would be greatly appreciated! Thanks, Steve Follow up Using the Electrical Maintenance Guide I isolated the drivers by pulling back the interface board but still have the same problem. I hear a relay or breaker click and all lights flash once?https://handibot.com/forum/read.php?2,3176,3176#msg-3176Tue, 21 Jul 2026 13:15:32 -0400 Phorum 5.2.22 https://handibot.com/forum/read.php?2,3176,3178#msg-3178 https://handibot.com/forum/read.php?2,3176,3178#msg-3178we are up and running again!
Steve]]> Steveibe Handibot ForumTue, 21 Aug 2018 19:07:10 -0400 https://handibot.com/forum/read.php?2,3176,3176#msg-3176 https://handibot.com/forum/read.php?2,3176,3176#msg-3176I turned the power off, waited for a bit but when I turn it back on after a second or so all that happens is one short simultaneous flash of a number of lights on the control card as well as the interface board. I blew any dust out of the enclosure and reseated the control card and ribbon connections, no change. I don't know what else to try, if anyone out there has any suggestions they would be greatly appreciated!
Thanks, Steve

Follow up

Using the Electrical Maintenance Guide I isolated the drivers by pulling back the interface board but still have the same problem.
I hear a relay or breaker click and all lights flash once?]]> Steveibe Handibot ForumSat, 18 Aug 2018 18:26:12 -0400