I am making an alignment tool to help me get my material in the proper place. I just a piece of .2" thick plexi that fits inside of the metal base portion, on top of the plastic. I want to engrave with a diamond tip bit a simple grid on it so that with it in place I can see through it to the material below to line up. If I make a 6" x 8" grid will there be any problem running the tool to the limits of the x/y or I should make it a little smaller to keep from hitting the limits? Thankshttps://handibot.com/forum/read.php?2,3551,3551#msg-3551Wed, 22 Jul 2026 00:10:42 -0400 Phorum 5.2.22 https://handibot.com/forum/read.php?2,3551,3553#msg-3553 https://handibot.com/forum/read.php?2,3551,3553#msg-3553
Thanks again]]> cuervo Handibot ForumThu, 12 Sep 2019 18:20:39 -0400 https://handibot.com/forum/read.php?2,3551,3552#msg-3552 https://handibot.com/forum/read.php?2,3551,3552#msg-3552 Brian Owen, ShopBot Handibot ForumThu, 12 Sep 2019 17:30:20 -0400 https://handibot.com/forum/read.php?2,3551,3551#msg-3551 https://handibot.com/forum/read.php?2,3551,3551#msg-3551 cuervo Handibot ForumThu, 12 Sep 2019 17:27:12 -0400