Spugnardi Wrote:
-------------------------------------------------------
> I just saw the hB this weekend and am close to
> pulling the trigger. I have a question about
> engraving on a lightly curved surface. Is the
> software and hardware capable of engraving on a
> small wooden paddle? The curve is shallow but it
> is curved.
Just do it, you won't be sorry.Yes, Vcarve will do this but unless you already have extensive experience expect to walk before you run!>
> Also. I see a user did a box joint with the wood
> vertical. Is there a plan out there for a jig for
> box joints, dovetails, and other joinery where the
> wood can be repeatably cut?
To my knowledge, there are no plans yet for joinery jigs. What the handibot lacks most is more people excited enough to work through things like this and share them! Work something out and share it and you will have done everyone a big favor. >
> Finally, do you see any reason why I could not cut
> carbon fiber?
I have been thinking about trying G10, there is no reason the hb could not cut CF just a matter of the right cutter, feed, and speed. Also you need to be aware that CF is quite nasty when airborne, not quite asbestos but pretty nasty. You would want a vacuum, a safe way to empty it, and a respirator. If you are not willing to take precautions for your safety, you should skip it and cut wood and plastic.