I've been using the handibot for several months now and enjoy it. I have a basic question I'm sure... If I do an x/y zero then go to zero my z axis, I have the ability to move the x and y at that point as well. Sometimes I would like to move it .25 to be right at the edge. If I (after I have alredy zeroed my x/y), move my y .25 and my z to top of plate, and click both the y and z to zero, does this change it? And, if I am tiling, is this applied each time I move the handibot (I figure it is)... if, for some reason, I would have to rezero the x/y, would I have to move it and zero it at i.e. .25 again?
And, if I did this, I'm assuming I could only move 7.75 inches if it's the 8 because of the .25 adjustment?
Thanks for info-hope it makes sense. Robin