Hi
I just received my Handibot 2.0 and its a wonderful piece of engineering.
My first cut (test file) completely successfully using the default (imperial) settings under the new web-based Fabmo App.
Since I am schooled using the metric system, I was happy that Handibot has this feature.
Unfortunately after switching to metric, all manual movements (X, Y, Z) are moving slowly as compared the imperial setting.
When I compared the imperial vs. the metric in the configuration setting, all of them has been multiplied with a constant of 25.4 except for the Junction Acceleration which remains at the value of 0.2. There is no improvement even when I changed it to 5 mm/min2.
For your advice on what should I do to use Metric setting.
Cheers
David
Edited 1 time(s). Last edit at 05/22/2016 11:32AM by Davidlhh.