Home
>
Handibot Forum
>
Topic
Handibot Quit!
Posted by Steveibe
|
Handibot Quit! August 18, 2018 06:26PM | Posts: 23 |
I was cutting a simple test job today on some MDF and my bot quit in the middle of the job.
I turned the power off, waited for a bit but when I turn it back on after a second or so all that happens is one short simultaneous flash of a number of lights on the control card as well as the interface board. I blew any dust out of the enclosure and reseated the control card and ribbon connections, no change. I don't know what else to try, if anyone out there has any suggestions they would be greatly appreciated!
Thanks, Steve
Follow up
Using the Electrical Maintenance Guide I isolated the drivers by pulling back the interface board but still have the same problem.
I hear a relay or breaker click and all lights flash once?
Edited 1 time(s). Last edit at 08/19/2018 02:01PM by Steveibe.
I turned the power off, waited for a bit but when I turn it back on after a second or so all that happens is one short simultaneous flash of a number of lights on the control card as well as the interface board. I blew any dust out of the enclosure and reseated the control card and ribbon connections, no change. I don't know what else to try, if anyone out there has any suggestions they would be greatly appreciated!
Thanks, Steve
Follow up
Using the Electrical Maintenance Guide I isolated the drivers by pulling back the interface board but still have the same problem.
I hear a relay or breaker click and all lights flash once?
Edited 1 time(s). Last edit at 08/19/2018 02:01PM by Steveibe.
|
Re: Handibot Quit! August 21, 2018 07:07PM | Posts: 23 |
Sorry, only registered users may post in this forum.