Hello,
Looking to make a replacement piece for one of our machines. I made the drawings and started to proceed cutting the piece out. The material is a White Delrin Acetal resin sheet 1 inch thick. I choose a 5.5 x 7 tile export with 6 different tiles.
The cuts look fine and start off well but once its starts getting into the meat for like 10 seconds later will create a common error 57. I replaced the cord to the Machine and even moved working from the garage to the house thinking maybe there could be power issues. Sometimes it runs longer than other runs but I need to completely reset The Z-axiz everytime and start from the beginning. I spend more time resetting the machine tand cutting air than material.
I have a flat up cut 1/4 inch bit for soft and hard plastics. Its set to 9 levels of cuts with a speed of 2 inches per second.
I'm thinking that maybe slowing it down to 1 inch per second might work to help prevent the error 57. I haven't tried it yet but was going to tomorrow. Any insight into the error would be appreciated.
Kind Regards
Rengized