Hello Brian, and thank you for advice. My comp and handibot are now on speaking terms thru Chrome.
I do have a question about my Z setting though...
I've been trying to cut out a piece of wood from .75 stock.
I set my Z to .80 to cut thru.
The warning pops up, I OK it.
Also hovering over the tool path in tool path list shows setting at .80
But when I run the machine I don't get a cut thru.
I have done fire up
I have done the reset via clip and plate ( I didn't remove the 90V) but ran the clip and plate reset.
It's as if Handibot sees the material as closer than it is.
My guess is I am missing something basic somewhere in settings?
Thanks, Ross.