Go Back to handibot.com
sign up or log-in

Advanced

Laser sight alignment

Posted by Kw 
Laser sight alignment
October 13, 2017 03:35PM
Hello,

I have a laser sight 2.0 and it does not match with a mill end. How can I adjust the position of laser sight?
Another issue is if I turn it on, it only stays a few minutes then it dims even with a new battery.
I bought it this March, if it has a defect, can I replace it?

I sent a message through 'Contact US!' in handibot.com but I didn't get any reply yet.
Thanks.
Re: Laser sight alignment
March 17, 2018 06:47AM
I am having same issues with the dimming in about 30 sec. To align the cross hairs used a pliers softly.
Re: Laser sight alignment
March 20, 2018 02:13PM
I've ordered some higher current capacity batteries to try out--The line lasers run on between 2.5VDV and 5VDC--The CR2032 batteries are 3V batteries--but it appears that they may be draining too quickly while the laser is on. I'll follow up here as soon as I've got ahold of some new batteries to test.
Re: Laser sight alignment
March 20, 2018 09:44PM
Batteries have a finite shelf life. It may be that the ones you bought were old stock. Try another retailer who would possibly have a higher turnover of stock.
Re: Laser sight alignment
March 21, 2018 10:54AM
I currently order mine through digikey--though there's no telling how long each has been on the shelf there. The ones that I just ordered are like 250mAh which should be double what we were getting previously.
Sorry, only registered users may post in this forum.