When I push the red button on the handibot to stop the machine to adjust something I can not start it again. On the computer it says Quit or Resume you can not do either the computer is froze, only way to resume is to turn off the handibot and start over.
Also when cutting yesterday I noticed a delay, I was using the arrows to move the router and would be a couple second delay more it would move, nothing different on Wi-Fi set up.
One last thing when tiling in the Y axis I put marks at 24" and does not line up correctly, I take my laser and mark my x=0, y=0 move the router to the end and mark where the laser line is and only 23 5/8" is that what I should be putting in for the y tile ?
Thanks in advance to all these newbie questions Bob