Go Back to handibot.com
sign up or log-in


4 Axis Stock

Posted by KCB22 
4 Axis Stock
August 25, 2019 05:13AM

I was looking at the Manual +2 Axis accessory, and wanted to check what size stock it can fit. The documentation says nothing larger than a 4 inch diameter cylinder. However, I am planning on working with square stock. What is the maximum dimensions for square stock when it is set up for 4 axis work?

Thanks in advance.

Re: 4 Axis Stock
September 12, 2019 04:18PM
Hey KCB -- I'm sorry! I thought I'd responded to this earlier -- for square stock, you'll need to measure across the diagonal of the square -- so max diagonal = 4" --> sqrt(4^2/2)= 2.82" on a side for the square stock.

Sorry, only registered users may post in this forum.