Toggle Clamps!!

So Mr Bill Young introduced me to these simple toggle clamps:



They have an off centered hole in the middle which means you can screw them into a bench, and hold down a piece against a fence, or another clamp easily.

I have made tons of these out of scraps. They are immensely useful and can be cut in minutes on a Handibot.

The GitHub link below has Sketchup files and VCarve files so you can make your own, or mod them as you wish!

[github.com]

I lifted these off of Bill as well when I was doing my pass-through table, I like them with a .5 hole and then I insert these plastic inserts.

[www.amazon.com]