Taking the picture was easy. What is not easy is figuring out how to get a picture in here... It seems that you have to have a url for the picture. At least it's not obvious that you can do it any other way. So the best I can do is a link to a post on goggle groups. I hope this works... This only took most of the evening but it's too cold in the shop to make sawdust anyway picture oby SimonSays - Handibot Forum
I got a set of T-handle allen keys and am now able to losten and tighten the motor bolts with the motoer in the highest possible position. One question though. When I do this, should I have the handibot on or off? Another thing I noticed was that there's a bit of interference between the router body and the angled plastic at the front. This happens when the widest part of the plastic on tby SimonSays - Handibot Forum
I tried loostening and re-tightening the bolts as you suggested. There was one bolt that I couldn't loosen with the Z as high as it would go because theat put the router next to the bolt and I couldn't get enough leverage holding the allen key vertically. So it took some fussing around with raisng and lowering the Z to get the bolts loosened. I retightened but no difference to the stiffby SimonSays - Handibot Forum
I finally had time (and warm enough weather) last weekend to take the handibot for a spin. Initial problems: I had trouble with the drivers not loading so I couldn't communicate with the handibot. I decided that I must have done something wrong when I installed the software so uninstallead and reinstalled then saw the error message that I didn't have .net framework. (I'm usiby SimonSays - Handibot Forum