Eric, I like the work table. I had made a couple of versions and like yours better. You said in your write up that you might make this open source. Are you willing to share cut files? Thanks and regards,by John777 - Handibot Forum
Back at home and reinstalled the anti backlash support. All is well. I had installed the connection to the base plate 180 degrees out of position. I just ran the x and y zero routine, and all worked as it should.by John777 - Handibot Forum
Brian, I am fairly certain that when I switched the base plate, the limit switch zero in the x axis no longer makes contact to trigger the switch, Perhaps I made some error during the installation . I bought the Indexing Jig, and got the base plate kit with it, since I have one of the early kickstarter models. I am away from home at the moment, and had it on my list to at least see if therby John777 - Handibot Forum
I bought the new base plate and installed it, and then found that the limit switches no longer work. I may be significantly out of date. How do I get the limit switches to work again?by John777 - Handibot Forum
Chad, thanks. I am sure that I heard that previously but I could not find it again. I have managed to import into Vcarve and output a tiled path set. I will post again once the cut is finished. Thanks.by John777 - Handibot Forum
I have downloaded some .v3m files and made cut files using PW3D. I did not find any method of outputting tiled cut files. How do I create tiled cut files for 3d projects? Thanks for any helpby John777 - Handibot Forum
@Jim Shockey, I am one of the people supposed to get my unit in September. Unfortunately I will be out of the country and cannot use it until October.by John - Handibot Forum
Hello Jim, II hope this it the place. Looking forward to a bit more activity than what is on the forum at this point. I am Near Dallas in Texas, How about you?by John - Handibot Forum
I am interested in information on when the inner circle persons plan to visit Durham, NC. I have been given some information, but am not clear if I will be the only one there at that time, or if others will be there. I would like to plan my visit so that I am not the only visitor. Thanks.by John - Handibot Forum