Here is a cheaper solution using Bench dogs and Spacers. The ELB fitted across the festoon hole spacing using T-Bolts and spacers it nicely clamps to the table. The good thing with this approach it is square to the table and cheap. You can make your own table with the correct hole spacing. I am trying to source single bench dogs of the correct height without the spacers - more to come onby John877 - Handibot Forum
Here is a suggestion for an accessory base. I have made some supports for my Festool MFT table. I had the 1.5 x 1.5 x 6 inch side pieces cut by 80/20 inc and then I cut a 1 inch slots to pass the T-slot bolts through. You can see them in the attached pictures on each corner. I added knobs so you can adjust and align the ELB Handibot This will give about an 1 inch space under the extendeby John877 - Handibot Forum
Thanks Brian, this process works. now at version 1.6.0 Johnby John877 - Handibot Forum
I managed the flash process to update my card. to version 1.4.2. after finding the drivers. When I the go to update from the control panel with the latest version, the update crashes repeatably tried about 5 times now. I am using the internet upgrade. Has anyone else had this problem Any advice on how to update to the latest? Johnby John877 - Handibot Forum
I am happy how they turned out after a little sanding - a great first project.by John877 - Handibot Forum
Just wanted to share my first attempt at a 4*8*3/4 sheet with the Shop Step project from the ShopBot web site. the x alignment was excellent the Y alignment was off in places by about a 1/4 inch, but all of these slight imperfections came out in the sanding process. (There was an imperfection in this sheet from another test/project that you will see in the photos, but wanted to share the expeby John877 - Handibot Forum