I know that I asked this question previously, but for the life of me I can't figure out where the answer is. I'm looking to flip my Handibot upside down and use it as a table router. What coding do I need to put in to manually turn the router on and off?by KCB22 - Handibot Forum
Handibot Team, I just upgraded my computer and am looking to install V-Carve on my new machine. However, the link which I historically used to access V-Carve 9.0 no longer works. Is there a new link which can be used? I previously used Thanks in advance!by KCB22 - Handibot Forum
Team, I was looking at the Manual +2 Axis accessory, and wanted to check what size stock it can fit. The documentation says nothing larger than a 4 inch diameter cylinder. However, I am planning on working with square stock. What is the maximum dimensions for square stock when it is set up for 4 axis work? Thanks in advance. Kevinby KCB22 - Handibot Forum
In case anybody else was curious - I just used my Handibot successfully in Germany using the 220V router and my standard American-style plug with a plug adapter.by KCB22 - Handibot Forum
Brian, Thanks for the response. Is the router all that is required to cause the voltage switch to occur? In place of purchasing a $30 cord, would an adapter like the one found at work so long as I have the 220v router plugged in?by KCB22 - Handibot Forum
Team, I currently own the Adventure Edition, living in the US. I just received word that I will be moving to Germany for the next 3-4 years, and want to take my Handibot along for the adventure. Before I spend more than $200 on the International Router, is there anything else that I would need to do in order to make sure the Handibot doesn't short-circuit once I plug it in on the other siby KCB22 - Handibot Forum
Sorry for reviving an old post, but I just want to verify Brian's post above. I currently have a Handibot Adventure Edition, 110V. If I move to Europe, I would still be able to use my Handibot just by purchasing a 220V router from the store?by KCB22 - Handibot Forum
Brian, Thanks for the quick response. I used it some more this weekend, and was not able to reproduce the issue. If it happens again then I will forward you the log. Kevinby KCB22 - Handibot Forum
Happy Memorial Day! I recently received my Handibot, and am using it to perform short Vcarve cutes (~30 seconds each). I am able to perform about a dozen cuts, but then the Handibot will stop responding to commands from FabMo. I have tried reconnecting FabMo from multiple devices, but the Handibot will not respond. I am able to continue navigating through FabMo, but any time I press a button wby KCB22 - Handibot Forum
As excited as I am for the extended Y axis to come out, I am very curious to know if there has been any progress on an official laser etching/cutter attachment for the Handibot. Have you been able to work on it, or has the extended axis been using all of your spare time?by KCB22 - Handibot Forum