So my machine unfortunately does not have the hole in the right side wall to turn the motor, but I did try shifting the X axis so the bracket is as snug to the carriage as possible, then making all of the adjustments again. Still no luck, it is still grinding as the carriage moves along?by Tyoung - Handibot Forum
So I tried this (even loosening the top rail) and I am still getting the grinding noise (as a quick test I am using the measure cutter macro, and that final motion when the motor moves along the x-axis before you put the aligator clip on is when the grinding happens, I am assuming because it is slower than the other motions along the x-axis) Additionally, when I loosen/remove the anti-backlashby Tyoung - Handibot Forum
Hi all... I am having issues with my X-axis stuttering and out of alignment on my V2 Handibot, so I went to adjust the alignment... using the directions for version 1, which led me to loosen all of the bolts holding the X-axis motor, instead of just the two specified in the directions for version 2. Now that I have found the directions to align the axis for V2, I can't get the axis back in aby Tyoung - Handibot Forum