Hi Everyone, Its been a while! Thank you all for your insight. I finally had a few days to really sit down again with the machine (and some cuts I want done to motivate me even more) and I think I figured out what the main issue has been all along. Deep in these forms, I found someone with a somewhat similar problem to what I was experiencing. And in fact, it was the mirrored image issueby HSU-JSMC-COBB - Handibot Forum
Hi Brian, Thank you, the 6" rule is great to know. But in this case, my design was only 4" in diameter along the X and Y axis. The multiple circles you see in the pictures are a result of multiple attempts at the same cut, with just moving the material back and forth to an un-cut section. Best, Cobbby HSU-JSMC-COBB - Handibot Forum
Hello everyone, Ran my first cut on my Handibot large sheet tool today. The first tool path went great- except the image I cut with the 90 Degree V-Bit was mirrored. I'm sure that is a setting I missed somewhere...so that's not really what my main concern is right now. My main question/concern, is about my failed profile path cuts. I am trying to cut a circle around the imageby HSU-JSMC-COBB - Handibot Forum