The tools or bits I'm using are the stock settings for Shopbot bits. I'll adjust and see if that helps. Again on the "High Speed Jerk" settings at 10000. Is that correct? Thanks Jack Tby jack49 - Handibot Forum
Thanks for the help. My "Maximum Jerk" is set to 25 but the "High Speed Jerk" is 10000 on the three main Axes XYZ. Should I adjust the Maximum Jerk only and should I go to 15 directly or try incremental steps like 20? Thanks Jack Tby jack49 - Handibot Forum
I have a follow up on the Handibot. This has shown up several times on a short cut leading to a right angle. I believe the router is moving on the -x axes. It is repeatable and does not happen on other pieces during the same cut. Any suggestions? Jackby jack49 - Handibot Forum
Just incase this happens to you. I was cutting some parts and ran the wrong tile cut file. A part popped out and the bit jammed. As I continued routing the remaining tile files. I had several files that were badly cut. Circles became ovals. It wasn't at all consistent in the errors. After several attempts I didn't realize that the router had moved on its attach point on the Handibot. Tby jack49 - Handibot Forum
I have attached an image of the update in the Handibot FINAL CHECK! Can you be more specific where to find these settings. I have opened up the Configuration button and found the Chordal Tolerance in General Tab. Is the XYZ Jerk settings in the Axes Tab? If so are you referring to Maximum Jerk (not me I hope)? If that is true mine was already set to 25. Also is this the latest CURRENT UPDATE Nby jack49 - Handibot Forum
One last thing. The clear plastic sleeve popped out of the dirt boot. Any suggestions on how to re-inset and glue/press-fit/wedge this back into place? Thanks Jack Tby jack49 - Handibot Forum
The dust collector on Handibot has a problem. A clear plastic insert popped out during a cut. Does anyone have an idea on how to get it to stay in place? Is it glued in or pressed into place? Thanks for the help Jack Tby jack49 - Handibot Forum
Just wanted to let you know that the FireFox browser works. I do have another question on the Fire-Up app. The button the to open the xyz motion control does not work on Chrome or Firefox. Is that suppose to work. The control button on the left does open the control pad. What was the reason from separating that from the coordinate panel? On another subject, sorry. I just purchased the Handibotby jack49 - Handibot Forum
I don't. It's the one I bought last week from Shopbot/Handibot. Jackby jack49 - Handibot Forum
This is the iPhone screen. Nice easy to access buttons. Jack Tinsleyby jack49 - Handibot Forum
This is a screen shot of the Arduino Pad. Notice the up and down buttons for the z axes. On my iPhone X they look normal and easy to use. Thanks Jackby jack49 - Handibot Forum
Just assembles the new Handibot Long Sheet Tool or Bridge. In a attempt to calibrate I have discovered a couple of problems. Using FabMo jog in the Z axes the buttons are very small buttons on the Android Pad. They are so close together it's very hard to choose one over the other. Also my Z axes seems to be jamming and looses the Z Zero location. Any suggestions. Jackby jack49 - Handibot Forum