I am trying to make some jigs for my handibot and need a cut depth of 2" from the bottom of the base plate. Using the bits I have now (basicaly the ones that came with the Handibot) I can only get a cut depth of about 1" when I seat the bit to the recommended depth. I have looked around online and have not been able to find a longer bit that will fit. Has anyone found a longer routerby Jeff - Handibot Forum
Some how my Kickstarter Handibot ripped the Y-Axis Limit Switch off, I think i happened during zeroing for the second run of the day, but I may have happened sometime during the previous cut. It looks like the solder pads got ripped off as well, so the whole switch assembly needs to be replaced. I am having trouble finding where to order a replacement. In my search I came across a referenceby Jeff - Handibot Forum
I finally had time to sit down and run through all of the suggestions here. It wound up being an issue with the x-axis screw alignment. If you watched it closely during moment you could see it shift alignment with the position of the carriage. It is not the the screw is warped( then it would flex as it rotate and would have hit at multiple points in a jog). To fix it I tried tightening thby Jeff - Handibot Forum
I have noticed during jog and cutting movements on my x-axis when the carriage reaches a certain spot (about 2" to the right of home) ts kind of grinds or rubs for about a 1/2"-1" or movement. On slow movement speeds (~1"/sec) this does not affect the positions, but when I try to run at the recommended jog speeds (~2"/sec) it throws the positioning off. I have one ofby Jeff - Handibot Forum