I got a itty bitty 1/32" kyocera router bit I would like to try and use but I can't seem to find the recommended speed settings for it? Where would I look or is it just a guess type of thing?by cuervo - Handibot Forum
that was what I needed, thanks again. Had to make a couple of adjustments but I finally had that moment when I broke the tabs off and looked at amazement at what I had made.by cuervo - Handibot Forum
the plate thickness setting, I assume that is the thickness of the plate to the work surface?by cuervo - Handibot Forum
so I finally got some time to work with this. On my first project I am just trying to cut out a ring that will allow me to mount a smaller gauge in a bigger hole. I have tried zeroing the Z-axis with the alligator clip or manually and with the clip it seems to cut about .1 too shallow and setting it manually seems like it does .2" too deep. Is there something I am still missing?by cuervo - Handibot Forum
thanks for the help I will check that out. I am trying to make a board to clamp things down to. I have merged the tool paths and when I go to tiling them it says it can't save them if the tool speeds are different. From what I can tell I am using the same tool with the same #'s for the 2 passes I need to make. What other speeds am I missing that is throwing it off?by cuervo - Handibot Forum
and I really wish I could get it on my network but it logs off and says its looking for fabmo and just keeps spinning? Anyone else on here?by cuervo - Handibot Forum
what am I doing wrong that the screen keeps getting hung up with a big STOP on the bottom? Seems the only way to clear it is to reset everything and start over?by cuervo - Handibot Forum
ah, that did the trick. It was set to default Thanks for all your help, I will pm my address as you requested. Thanks again so very much.by cuervo - Handibot Forum
Thanks for your response. Yes input #1 does light up when I tap the clip to the plate. Software version says its V 1.6by cuervo - Handibot Forum
I recently got a handibot used and I am new to cnc and learning. IF there is anyone in the southern indiana/Evansville area it would be a great help.by cuervo - Handibot Forum
I am new to the cnc world after finding a handibot on craigslist. I am told it is a V2 but I can't see any markings on it anywhere to determine which one it is? I tried to get started and just set the z-axis setting. I followed the instructions, with the alligator clip but it just drove the bit down into and past the point it should and started bending the tab its supposed to barely touchby cuervo - Handibot Forum