That's right, carefully lay down a 6X8 matrix starting from where your zero point for the project will be. There are cursors cut into the baseplate at both the X and the Y zero. If you use the jig and then index over your 6 inches, you should line up perfectly with your next set of lines. It is what I sometimes call belt and suspenders solution. One could do the job but with both we are sure.
Vogt886 Wrote:
-------------------------------------------------------
> one more thing... hoping to try the tiling
> tomorrow...when you say to "pencil marking your
> board in addition to the jig"... where do you
> pencil mark so you know for sure how far to move
> the handibot? Thanks, Robin