Go Back to handibot.com
sign up or log-in


Duh moment...

Posted by Mike 
Duh moment...
September 26, 2016 12:30PM
Finally starting to use my kickstarter Handibot. Note to anyone else in a similar situation... it's kind of hard to cut through a piece of material thicker than the cutting length of the bit. Only took 4 tries to figure out that was the issue.
Re: Duh moment...
September 26, 2016 05:04PM
Mike; I think we've all been there before! Also just to be sure--did you check that the handibot wasn't running out of Z travel? If it is, you can always adjust the position of the router in its bracket or let the bit hang a bit farther out from the collet
Re: Duh moment...
September 26, 2016 05:16PM
Trust me on this, this won't be your last time.spinning smiley sticking its tongue out
Sorry, only registered users may post in this forum.