I don't have the Handibot to verify this, but it seems to run on my Intel Edison setup if you edit the .sbp file (Auto Rail Maker.sbp) and change the two MSGBOX lines where it prompts to release and clamp the material to use a PAUSE preceded by a comment line to prompt the user.
For example:
'Release hold down clamps so we can slide the material over.
PAUSE
and
'Clamp material back down for the next cut.
PAUSE
Make the modifications and then submit the job from Job Manager and specify the location of the Auto Rail Maker.sbp file that you modified.
However, if I tried to preview the job, nothing is previewed and Job Manager quit working for me until I restarted fabmo.
Can't figure out why the file is causing Preview and Job Manager problems.
[Edit] It seems that Preview does not like the GOTO statement in the .sbp file.
Edited 1 time(s). Last edit at 01/04/2017 08:54AM by gclayton.