I have been losing my Fabmo connection on and off for a while now. It hasn't caused any major issues yet besides being very annoying resetting XYZ and zero over and over. Also, there are times when I first try to connect it takes several attempts, me power cycling Handibot and closing and reopening browser. Today repeatedly when setting XYZ, on the last forward bump it would freeze up with stop flashing and I would have to go thru the whole routine again. Once I did get to the point where I could set zero and run the small job I had loaded (centered on 6x8) it would start on the far left and crash into the housing?
I would sure appreciate if someone could tell me where to go from here.
Thanks, Steve
I am adding this after returning home a few hours after the above post. I tried re-tooling the same job thinking the script could have been corrupt but got the same results. Still thinking it may be a Vcarve output error or something along those lines I loaded and air carved a file I had run recently and it ran fine. Fabmo also seemed more responsive but the dropping connection and posting "Waiting for Fabmo" has been a ongoing issue. I should also mention that I successfully installed the macro installer app earlier today.
Edited 2 time(s). Last edit at 03/30/2017 10:21PM by Steveibe.