Thanks mark. The file is a design that is 18x18. The design is then set as a tiled file with 6x6 tiles and saved in tile format. I could use a jig at that point and cut the 18x18 design out of one piece of material. I don't want to do that, but want to cut each tile individually, so 9 tiles, each 6x6
I want to cut each tile by setting the 6x6 tile individually at the 0,0 position and cut it using the tiled cut file. So T1' cut using the T1 file, etc through all the individual tiled files, replacing the material each time with a new 6x6 block placed at 0,0. Because I'm using tiled files, the machine thinks T2 is to start at 6,0 as an origin.
After I cut each piece, usually out of different wood types and grains to add artistic interest, I can assemble the 9 pieces in a frame and have the completed design cut
Hope that helps and thank you for your suggestions
Dennis